AMO-III DS pumps

 

 

1.8l 3l
1.8l
3l
  • Capable of operation over a wide working  viscosity range.
  •  Digital display tells how the pump is doing on sight.
  •  Control by timer and counter is selectable.。

Specifications

Pump Discharge
volume
150ml /min (50Hz), 180ml /min (60Hz)
Discharge
pressure
2.0MPa (safety valve setting)
Mortor Power AC100Vφ1/0.83A, AC200Vφ10.41A (50Hz)
AC100Vφ1/0.64A, AC200Vφ1/0.33A (60Hz)
Output 20W (50Hz/ 60Hz) Capacitor motor
Controller Timer
Discharge time adjustable range: 1~99 seconds
Interval time adjustable range: 1 to 9999 minutes
1 to 9999 counts

*Please specify when ordering if you want to count control.

Abnormal
output
Contact type A Contact (NO)
Contact capacity AC250V 1.5A
Abnormality
detection
Oil level pressure
Oil level
switch
Contact type A Contact (NO) ON at low level
Prerssure
switch
Contact type B Contact (NC)
Operating pressure: 1.7MPa OFF
Reset pressure: 0.9MPa ON
Liquid crystal
display
INTERVAL display ”INT”
DISCHARGE display ”DIS”
ALARM When oil side decreases,
display ”OILLEVEL ERR”
When pressure is abnormal,
display ”PRESSURE ERR”
Working
viscosity range
68~1800mm2/S (50Hz)
Reservoir
capacity
1.8l,3l (plastic) 3l,4l,8l (sheet metal)
Weight 1.8l Reservoirs: 3.2kg 3l Reservoirs: 4kg

How To Order

Automatic intermittent gear pump AMO-III DS Part Number

Model

Model Part Number
AMO-III DS-1 285301
AMO-III DS-1-3 285303
AMO-III DS-2 285302
AMO-III DS-2-3 285304

Directions for use

Do not remove the oil strainer to keep the pump clear of foreign matter.
Replace or clean the suction filter at least once a year. Click here to view the service list.
Oil viscosity varies with oil temperature. Be sure to use oil within specified working viscosity range. Click here to view the viscosity list.
Do not use any special additive-contained oil, water soluble oil and solvent.
Periodically check the oil in the reservoir for impurities. Replace it, if necessary, with fresh oil immediately. Be sure to clean the reservoir before oil change.
Make sure that proper voltage and pressure are proper.
Do not overtighten the discharge joint.
Refer to the tightening torque table.
Low-oil viscosity versions are available. Contact us for information.
For system planning information, click here.
* Should the pump malfunction, Contact us for immediate response with substitution.

Drawing

Controller Setting
コントローラー設定
Hydraulic circuit drawing
Hydraulic circuit drawing
Wiring digram
Wiring digram
Dimensional drawing
Dimensional drawing